SPL Iron for tracking high tube bias fast attack / release.
SPL Iron on master SLOW att/rel
Slight Elysia karakter 500
Slight IGS Rubberbands 500 mastering EQ
Slight Kush Elektra 500
Slight ELysia NVelope 500
That's some monstrous low end you got there cube3!
The sustained notes on the bass are really taking a toll on smaller speakers and clouding everything with them...
I would dial that back a good notch, perhaps cut some sustain as well...
The vocals are a bit muffled and could use some air.
Drums are a tad too compressed (I hear it in the cymbals mostly, so perhaps you could use some parallel compression and remove the high end from the send to a parallel compressor?)
Tones are not bad overal, balance is fine so if you start by clearing the low end, you should have a reasonable mix...
Oh and the end should really be a fade out, it doesn't make much sense to end it like that!
(08-04-2016, 08:34 PM)ptalbot Wrote: [ -> ]That's some monstrous low end you got there cube3!
The sustained notes on the bass are really taking a toll on smaller speakers and clouding everything with them...
I would dial that back a good notch, perhaps cut some sustain as well...
The vocals are a bit muffled and could use some air.
Drums are a tad too compressed (I hear it in the cymbals mostly, so perhaps you could use some parallel compression and remove the high end from the send to a parallel compressor?)
Tones are not bad overal, balance is fine so if you start by clearing the low end, you should have a reasonable mix...
Oh and the end should really be a fade out, it doesn't make much sense to end it like that!
Thank you for your feedback, very nice work on this track b.t.w.
I have done some eq shelving in the low freq and used Kush Clariphone for presence / air on the vocal and snare. The Master Comp, is now on Fast, with High tube bias. I have removed the Low freq sustain (I did that on the Elysia Nvelope 500, i sometimes get to greedy with it).