24-04-2018, 03:52 PM
There's a couple of things that presented as trouble areas in this first mix. The shaker was too loud, often masking cymbals and hi-hats in the drum mix. The basses got "boomie" on occasion so low cuts were made at 35Hz and 24dB /octave. There were some sibilant issues in the vocals, and the keyboard parts were buried most of the time. I think I've corrected each of those problems in the mix.
In this master, I believe I'm correcting resonant frequencies, specifically, at about 210Hz I made a sharp cut of about 6dB, Q of 6.293. Likewise, at 2.1kHz there's a sharper cut of 6.25dB, Q of 10.727. The low cut is at 40Hz and 24dB / octave.
Let me know if I've made improvements or need to go back to "the drawing board" and try again.
In this master, I believe I'm correcting resonant frequencies, specifically, at about 210Hz I made a sharp cut of about 6dB, Q of 6.293. Likewise, at 2.1kHz there's a sharper cut of 6.25dB, Q of 10.727. The low cut is at 40Hz and 24dB / octave.
Let me know if I've made improvements or need to go back to "the drawing board" and try again.
Peace,
Dave
Mid 2019 Mac Pro; Focusrite Scarlet 18i20 USB2 audio interface; Logic Pro X; FabFilter C2, DS, L1, Q3, R, Saturn2, Timeless2 ; Native Instruments Komplete 13; Waves 12 Gold; Rokit 6 G3 monitors; AKG K240 MKII and Beyerdynamic DT990 Pro cans.
Dave
Mid 2019 Mac Pro; Focusrite Scarlet 18i20 USB2 audio interface; Logic Pro X; FabFilter C2, DS, L1, Q3, R, Saturn2, Timeless2 ; Native Instruments Komplete 13; Waves 12 Gold; Rokit 6 G3 monitors; AKG K240 MKII and Beyerdynamic DT990 Pro cans.