SPL Iron tracking - Printable Version +- Discussion Zone (http://discussion.cambridge-mt.com) +-- Forum: 'Mixing Secrets' Free Multitrack Download Library: mixing forum (http://discussion.cambridge-mt.com/forumdisplay.php?fid=184) +--- Forum: Acoustic, Jazz, Country, Orchestral (http://discussion.cambridge-mt.com/forumdisplay.php?fid=2) +---- Forum: Ghostly Beard: 'A Reason To Leave' (http://discussion.cambridge-mt.com/forumdisplay.php?fid=280) +---- Thread: SPL Iron tracking (/showthread.php?tid=14674) |
SPL Iron tracking - cube3 - 08-04-2016 SPL Iron for tracking high tube bias fast attack / release. SPL Iron on master SLOW att/rel Slight Elysia karakter 500 Slight IGS Rubberbands 500 mastering EQ Slight Kush Elektra 500 Slight ELysia NVelope 500 RE: SPL Iron tracking - ptalbot - 08-04-2016 That's some monstrous low end you got there cube3! The sustained notes on the bass are really taking a toll on smaller speakers and clouding everything with them... I would dial that back a good notch, perhaps cut some sustain as well... The vocals are a bit muffled and could use some air. Drums are a tad too compressed (I hear it in the cymbals mostly, so perhaps you could use some parallel compression and remove the high end from the send to a parallel compressor?) Tones are not bad overal, balance is fine so if you start by clearing the low end, you should have a reasonable mix... Oh and the end should really be a fade out, it doesn't make much sense to end it like that! RE: SPL Iron tracking - cube3 - 09-04-2016 (08-04-2016, 08:34 PM)ptalbot Wrote: That's some monstrous low end you got there cube3! Thank you for your feedback, very nice work on this track b.t.w. I have done some eq shelving in the low freq and used Kush Clariphone for presence / air on the vocal and snare. The Master Comp, is now on Fast, with High tube bias. I have removed the Low freq sustain (I did that on the Elysia Nvelope 500, i sometimes get to greedy with it). |