07-09-2018, 05:10 PM
(This post was last modified: 07-09-2018, 05:14 PM by Sasquatch1974.)
No problem. A good idea for stereo spread I discovered recently is to run your two wide guitars to a stereo reverb send (with no widening, i.e. if you sent a mono in, you get mono out). Place a utility plugin just before it and swap the channels. Make sure you EQ the reverb to not get any masking and, Hey presto, you get the reverb of each guitar in mono in the opposite channel 
It also helps to balance the channels if one guitar part is playing solo, or is a lot fuller than the other one.
It also helps to balance the channels if one guitar part is playing solo, or is a lot fuller than the other one.