Patrick Talbot -Fool

[KMuzic]

Thanks Lucas

Pretty simple Bass FX chain ,, Used BlueCat TriplEQ with just a 4db bell curve reduction at 180 Bass parallel compressed to ReaComp Compressor 1.1 to 1 Ratio-
3.0ms Attack- 50ms Release- 3.0db Knee- lowpass 11,000hz-Highpass110hz- RMS Size 36.0- 100% Wet w/Automakeup.

It is loud in the headphones...I should probably find the middle ground before rendering....thanks for noticing that,


Thanks Lucas for checking it out

Cheers

K

Interesting K. Just wondering whats your preference is with using triplEQ over ReaEQ. I can see it has mid side capabilities which could be useful.
I also found your Comp setting quite interesting also. I haven't tried a low ratio with the high RMS setting. How did you come about these setting? I'm guessing it would have a good leveling ability whist allowing the bass detail to be dialled in. I'm going to have to experiment with these settings myself. I'm intrigued.

Hi Dave

I use ReaEQ quite a bit .. when I need to just pull down or push up one specific range I just got used to using the Black CatEQ . As far as the Comp setting , that was a mistake, that's one of my master buss presets that Ill use sometimes elsewhere with a 4 or 6 to1 ratio, I forgot to change the setting. seemed to have worked out ok..lol I may try it again on a bass track.

Cheers

K