05-06-2023, 09:59 PM
Kick needs a low shelf at minus 1.5 dbs on 45hz and or use a high-pass filter at around 50 60hz and you're set.
You can also fix the little rumbling on the kick tail by increasing the compressor release a bit.
The bass needs a high-pass filter at 55-70hz. It make the whole track less muddy.
Lower vocals delay a bit. You can also use the low pass filter built in the delay to attenuate the His from the delay. I suggest make delay stereo my friend.
I like the acoustic guitars. Some people pay little to no attention to acoustic guitars processing.
You can also lower or mute some of the string section. It'll make the song less cluttered.
E. Guitars sound good my friend.
The whole drumset sounds a bit dry.(it is not your fault) You can send the whole drum tracks to a bus and use a medium hall reverb at 100 percent mix. Then you can adjust the drums verb to your liking.
There are a few things you can always fix here and there.
You can also fix the little rumbling on the kick tail by increasing the compressor release a bit.
The bass needs a high-pass filter at 55-70hz. It make the whole track less muddy.
Lower vocals delay a bit. You can also use the low pass filter built in the delay to attenuate the His from the delay. I suggest make delay stereo my friend.
I like the acoustic guitars. Some people pay little to no attention to acoustic guitars processing.
You can also lower or mute some of the string section. It'll make the song less cluttered.
E. Guitars sound good my friend.
The whole drumset sounds a bit dry.(it is not your fault) You can send the whole drum tracks to a bus and use a medium hall reverb at 100 percent mix. Then you can adjust the drums verb to your liking.
There are a few things you can always fix here and there.