Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Iron Sheik - Quick evening headphone mix
#3
Hey!

I just went back and took a look at the project (took me a while to find it, it was sitting in the recycle bin haha) and it looks like I tried out some fun tricks here.

Oh and by the way, I totally agree the toms are over the top listening to them now.

The bass drum was pretty simple, I cut around 5dB at both 230 and 680Hz and just shelved the top end by +12dB from 2.5K upwards. Then hit an 1176, slow attack, fast release, 4:1 ratio for anywhere between 3 and 7dB of compression.

I probably would have wanted a super bright snare but there's a ton of cymbal bleed when you boost the top end on this recording, so this is where I got weird with it. I EQ'd the snare to where I'd want it (ignoring the bleed for now), boosting 15dB at 6.1K, 8dB at 3.4K and 5dB at around 200Hz. Then added a tiny bit more top and bottom with a different EQ. Then I duplicated the track with the same EQ applied. On the duplicate track I added a compressor before the EQs that basically just squashes down completely whenever the snare is hit (I'll add a screenshot for this), and an EQ at the and of the chain that filters out most of the body of the snare. I then flipped the phase on the duplicate, essentially cancelling out most of the cymbal bleed above like 1KHz when played together with the original.
This is sort of like an alternative to gating. Personally I don't like the sound of gated drums, especially when there's a good amount of cymbal bleed. You get that nasty "chhh" sound when the gate opens.
Anyway, after that I compressed the snare tracks together, slow attack, medium release for around 5dB of compression, and clipped them slightly so they pop out more in the mix without the actual transient registering too high.
I also blended in a roomy sample to sort of fill in the gaps and add a little more consistency, but it's like 20% of the sound when blended.

I used the same trick for the bleed on the toms after chopping up the tracks. On all toms I cut quite a lot of mids at roughly 250 and 700Hz, and gently high passed them, the frequency depending on the tuning. And boosted a bit at 6-7KHz. No compression on the tracks themselves but I did clip them slightly, like the snare.

I sent all the close mics to a parallel compression bus, running a Fairchild 670 emulation into an EQ boosting around 2.5dB at 65Hz and 8KHz.

Last thing really is a short room reverb that I sent the snare and toms to to add some sustain.

I think a decent clipping limiter for drum mics is so useful in rock music. It just allows you to get them really gut-punching. Honestly I feel like it's such a good tool I probably could have just said "use a clipper on the drums" instead of writing this haha, assuming you're not already using one.

Hope this helps!


Thumbnail(s)
   
Reply


Messages In This Thread
RE: Iron Sheik - Quick evening headphone mix - by Pasta - 02-02-2019, 05:00 PM