19-02-2019, 07:01 PM
(18-02-2019, 02:27 AM)jgrab Wrote: Nice! Did you add the sub boom to a couple sections to mark when they come in?
If the vocals and solo come down a touch, you could probably get another 3dB out of the mix before running into clipping issues.
I've used a transient shaper on the sub boom (kick sample) to enhance the low end and pull down the attack a bit. Afterwards, the signal goes trough a reverb, which only slightly adds stereo room. This signal chain enters a limiter to compress and push it a bit.
I had the feeling that the solo is a bit to quiet around 1-2db and the vocals are a bit to loud.